Contactor installation manual

Installation Manual By Firstech LLC, Version: Applicable to the following remote start system: CM – Auto Only Starter Control Module This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions; (1) This device may not . This instruction manual covers the description, inspection, installation, operation and maintenance of Joslyn Clark’s USAVAC CV compact series of low voltage vacuum contactors. CV77UA - V A, /VAC Control Voltage, 2NO 2NC Auxiliary Configuration. c3controls’ line of Standard Contactors and Miniature Contactors and Control Relays are easy to install and designed to perform in a broad range of global applications. Available with AC or DC coils, DIN rail and panel mounting, IP20 guarded terminals, multi-point coils, and include a wide variety of shared accessories. Integral Auxiliary.

• Ensure contactor is properly aligned with piping, and flanges are adequately tightened after cleaning. Always conduct system checks in accordance with installation instructions and facility policies prior to operation. • Ensure proper draining and flushing of contactor before maintenance, service, or shipping of contactors. NOTICE. c3controls' line of Standard Contactors and Miniature Contactors and Control Relays are easy to install and designed to perform in a broad range of global applications. Available with AC or DC coils, DIN rail and panel mounting, IP20 guarded terminals, multi-point coils, and include a wide variety of shared accessories. Integral Auxiliary. instructions. Installation Instructions for Rotating Biological Contactor Unit with Finish Bore 1. The shaft on which the reducer is to be mounted must be straight, clean and free of burrs. Lubricate the shaft to ease the mounting of the reducer. (Anti-fretting grease is recommended for finished bore only.) A lifting lug is provided to lift the.

line contactor (leave actual connection to the battery loose for now). On the oppRVLWH terminal connect a red coded cable to B+ on the controller. From B+ on the controller connect a cable to A1 on the motor. From A2 on the motor connect to directional contactor terminal A. From S2 on the motor connect a cable to directional contactor C. 1. Power panel; (one contactor for open transition; 2 contactors for closed transition). 2. Voltage selection and transformer panel (if required); and 3. Microprocessor-based logic panel. Figure 5. Contactor Based ATS ( A). Each panel is independently mounted with interconnecting wiring terminated at the connector receptacles on the ATC or. Steps for Installation 1. Remove the existing roller bracket from the contactor moving armature, if one is attached. 2. Secure the new roller bracket and bearing assembly with two 6mm x 25mm bolts with lock washers and torque to 85 in-lb ( N-m).