How manual boost controller works

 · A manual boost controller (MBC) is a hand-operated device that modifies the amount air pressure from a turbocharger that is allowed to enter the intake manifold. By regulating the amount of air pressure, the total amount of available air is also being regulated. A turbocharger is powered by the engine’s exhaust gas and is limited by a device on the turbo called a wastegate.  · Install the Boost Tee in the wastegate pressure line with the wastegate arrow pointing towards the bottom port on the wastegate. Secure all silicone hose ends with hose clamps. Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws. Make sure the boost dial is turned Estimated Reading Time: 3 mins. In our design, the stem gets screwed in and out of the body which changes the spring pressure on the ball. One key thing to our MBC (Manual Boost Controller) is our bleed hole. In the stem is a bleed hole that serves 2 purposes. One is to relieve pressure .

Mechanical (Manual) Boost Controllers. A mechanical boost controller (also known as a manual boost controller) is a set-and-forget type of setup. You dial-in the exact amount of boost you want via manual knob, close the hood, and the controller will maintain that level regardless of throttle position, engine speed, or atmospheric conditions. Manual boost controllers are simple, cost-effective ways to increase boost; A boost controller works by interrupting the pressure being sent to the wastegate; It works with both an internal or external wastegate; A high-quality boost gauge is a necessity when you install a mechanical boost controller. Mechanical (or manual) boost controllers offer up to two boost settings set by the driver and controlled via a switch. They are easy to fit, simple in operation and require little maintenance. Electronic boost controllers are a far more sophisticated solution offering a host of boost settings mapped against different triggers like gear change.

Manual boost controllers are simple, cost-effective ways to increase boost; A boost controller works by interrupting the pressure being sent to the wastegate; It works with both an internal or external wastegate; A high-quality boost gauge is a necessity when you install a mechanical boost controller. Install the Boost Tee in the wastegate pressure line with the wastegate arrow pointing towards the bottom port on the wastegate. Secure all silicone hose ends with hose clamps. Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws. Make sure the boost dial is turned. In this video I explain how manual boost controllers work. They're just valves that only allow certain pressures to open them, very simple. go from $10 to +$.